Search results
Results from the Think 24/7 Content Network
The first-generation iPad Pro (12.9-inch models only), and the second-generation iPad Pro, are the only devices with the Lightning connector supporting USB 3.0 host. [9] The only accessory released with USB 3.0 support is the Lightning to USB 3 Camera Adapter. [10] Since iPhone 8 and iPhone X, the Lightning connector is somewhat USB-PD ...
A USB cable, by definition, has a plug on each end—one A (or C) and one B (or C)—and the corresponding receptacle is usually on a computer or electronic device. The mini and micro formats may connect to an AB receptacle, which accepts either an A or a B plug, that plug determining the behavior of the receptacle.
USB On-The-Go ( USB OTG or just OTG) is a specification first used in late 2001 that allows USB devices, such as tablets or smartphones, to also act as a host, allowing other USB devices, such as USB flash drives, digital cameras, mouse or keyboards, to be attached to them. Use of USB OTG allows devices to switch back and forth between the ...
The Mini-USB connectors (Mini-A, Mini-B, Mini-AB) were introduced for mobile devices, but they were quickly replaced by the thinner Micro-USB connectors (Micro-A, Micro-B, Micro-AB). The Type-C connector, also known as USB-C , is not exclusive to USB, is the only current standard for USB, is required for USB4, and is required by other standards ...
USB communications device class (or USB CDC) is a composite Universal Serial Bus device class. The communications device class is used for computer networking devices akin to a network card, providing an interface for transmitting Ethernet or ATM frames onto some physical media. It is also used for modems, ISDN, fax machines, and telephony ...
The idle line state is when the device is connected to the host with a pull-up on either D+ (for full speed USB 1.x) or D− (for low speed USB 1.x), with transmitter output on both host and device is set to high impedance (hi-Z) (disconnected output). A USB device pulls one of the data lines high with a 1.5 kΩ resistor.
USB killer. (Redirected from USB Killer) A USB killer is a device that is designed to be portable and sends high-voltage power surges repeatedly into the data lines of the device it is connected to, which will damage hardware components on unprotected devices. Companies selling the device state it is designed to test components for protection ...
20 Gbit/s (2.422 GB/s, USB 3.2 Gen 2x2) A deprecated [ 2] SuperSpeed USB 5 Gbit/s packaging logo. Universal Serial Bus 3.0 ( USB 3.0 ), marketed as SuperSpeed USB, is the third major version of the Universal Serial Bus (USB) standard for interfacing computers and electronic devices. It was released in November 2008.