Search results
Results from the Think 24/7 Content Network
1:10 scale radio-controlled car. ( Saab Sonett II) A radio-controlled model (or RC model) is a model that is steerable with the use of radio control (RC). All types of model vehicles have had RC systems installed in them, including ground vehicles, boats, planes, helicopters and even submarines and scale railway locomotives.
t. e. Pulse-position modulation ( PPM) is a form of signal modulation in which M message bits are encoded by transmitting a single pulse in one of possible required time shifts. [1] [2] This is repeated every T seconds, such that the transmitted bit rate is bits per second. It is primarily useful for optical communications systems, which tend ...
Proportional control, in engineering and process control, is a type of linear feedback control system in which a correction is applied to the controlled variable, and the size of the correction is proportional to the difference between the desired value ( setpoint, SP) and the measured value ( process variable, PV).
Radio control (often abbreviated to RC) is the use of control signals transmitted by radio to remotely operate a device. Examples of simple radio control systems are garage door openers and keyless entry systems for vehicles, in which a small handheld radio transmitter unlocks or opens doors. Radio control is also used for control of model ...
Spektrum 2.4 GHz 3-channel radio. Brushless motor. The Arrma RC Car Typhoon 6S V5 BLX Buggy uses a LiPo (lithium polymer) battery with an optional pinion gear and can reach a blazing top speed of ...
Various scale sizes of RC scale aircraft have been built in the decades since modern digital-proportional, miniaturized RC gear came on the market in the 1960s, and everything from indoor-flyable electric powered RC Scale models, to "giant scale" RC Scale models, in scale size ranges that usually run from 20% to 25%, and upwards to 30 to 50% ...
The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.
The standard engine in the GV70 is a 2.5-liter turbocharged inline-four producing 300 horsepower and 311 pound-feet of torque. All-wheel drive is standard on every GV70, as is an eight-speed ...