Ad
related to: digital proportional radio control system charger
Search results
Results from the Think 24/7 Content Network
t. e. Pulse-position modulation ( PPM) is a form of signal modulation in which M message bits are encoded by transmitting a single pulse in one of possible required time shifts. [1] [2] This is repeated every T seconds, such that the transmitted bit rate is bits per second. It is primarily useful for optical communications systems, which tend ...
1:10 scale radio-controlled car. ( Saab Sonett II) A radio-controlled model (or RC model) is a model that is steerable with the use of radio control (RC). All types of model vehicles have had RC systems installed in them, including ground vehicles, boats, planes, helicopters and even submarines and scale railway locomotives.
Proportional control, in engineering and process control, is a type of linear feedback control system in which a correction is applied to the controlled variable, and the size of the correction is proportional to the difference between the desired value ( setpoint, SP) and the measured value ( process variable, PV).
A reed receiver or tuned reed receiver (US) was a form of multi-channel signal decoder used for early radio control systems. It uses a simple electromechanical device or 'resonant reed' to demodulate the signal, in effect a receive-only modem. The encoding used is a simple form of frequency-shift keying . These decoders appeared in the 1950s ...
Pulse-width modulation ( PWM ), also known as pulse-duration modulation ( PDM) or pulse-length modulation ( PLM ), [1] is any method of representing a signal as a rectangular wave with a varying duty cycle (and for some methods also a varying period ). PWM is useful for controlling the average power or amplitude delivered by an electrical signal.
Radio control (often abbreviated to RC) is the use of control signals transmitted by radio to remotely operate a device. Examples of simple radio control systems are garage door openers and keyless entry systems for vehicles, in which a small handheld radio transmitter unlocks or opens doors. Radio control is also used for control of model ...
In electronics and telecommunications, modulation is the process of varying one or more properties of a periodic waveform, called the carrier signal, with a separate signal called the modulation signal that typically contains information to be transmitted. [ 1] For example, the modulation signal might be an audio signal representing sound from ...
The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.
Ad
related to: digital proportional radio control system charger