Search results
Results from the Think 24/7 Content Network
Radio control (often abbreviated to RC) is the use of control signals transmitted by radio to remotely operate a device. Examples of simple radio control systems are garage door openers and keyless entry systems for vehicles, in which a small handheld radio transmitter unlocks or opens doors. Radio control is also used for control of model ...
The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.
Block diagram of a crystal radio receiver Circuit diagram of a simple crystal radio. A crystal radio can be thought of as a radio receiver reduced to its essentials. [3] [39] It consists of at least these components: [22] [40] [41] An antenna in which electric currents are induced by radio waves.
Radio transmitter design. A radio transmitter or just transmitter is an electronic device which produces radio waves with an antenna. Radio waves are electromagnetic waves with frequencies between about 30 Hz and 300 GHz. The transmitter itself generates a radio frequency alternating current, which is applied to the antenna.
Antenna (radio) In radio engineering, an antenna ( American English) or aerial ( British English) is an electronic device that converts an alternating electric current into radio waves, or radio waves into an electric current. [ 1][ 2] It is the interface between radio waves propagating through space and electric currents moving in metal ...
Radio receiver design includes the electronic design of different components of a radio receiver which processes the radio frequency signal from an antenna in order to produce usable information such as audio. The complexity of a modern receiver and the possible range of circuitry and methods employed are more generally covered in electronics ...
The RF front end consists of the components on the left colored red. In a radio receiver circuit, the RF front end, short for radio frequency front end, is a generic term for all the circuitry between a receiver's antenna input up to and including the mixer stage. [1] It consists of all the components in the receiver that process the signal at ...
Battery eliminator circuit. In battery-powered equipment, a battery eliminator circuit ( BEC) is an electronic voltage regulator used to power a subsystem at a different voltage without the need for a supplemental battery. BECs are commonly used in radio-controlled models, which need separate voltages to power the motor and the R/C equipment.