Search results
Results from the Think 24/7 Content Network
Radio control (often abbreviated to RC) is the use of control signals transmitted by radio to remotely operate a device. Examples of simple radio control systems are garage door openers and keyless entry systems for vehicles, in which a small handheld radio transmitter unlocks or opens doors. Radio control is also used for control of model ...
The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.
This circuit diagram shows the interconnections of parts for a very basic preselector which goes between and antenna and a radio. Source Drawn using free software by me using a well known circuit Date 2014-10-29 Author JNRSTANLEY. Permission (Reusing this file) See below.
The radio spectrum is the part of the electromagnetic spectrum with frequencies from 3 Hz to 3,000 GHz (3 THz ). Electromagnetic waves in this frequency range, called radio waves, are widely used in modern technology, particularly in telecommunication. To prevent interference between different users, the generation and transmission of radio ...
У = RF amplifier stages, Д = frequency discriminator stage. In radio equipment, Automatic Frequency Control ( AFC ), also called Automatic Fine Tuning ( AFT ), is a method or circuit to automatically keep a resonant circuit tuned to the frequency of an incoming radio signal. It is primarily used in radio receivers to keep the receiver tuned ...
The RF front end consists of the components on the left colored red. In a radio receiver circuit, the RF front end, short for radio frequency front end, is a generic term for all the circuitry between a receiver's antenna input up to and including the mixer stage. [1] It consists of all the components in the receiver that process the signal at ...
Radio receiver design includes the electronic design of different components of a radio receiver which processes the radio frequency signal from an antenna in order to produce usable information such as audio. The complexity of a modern receiver and the possible range of circuitry and methods employed are more generally covered in electronics ...
Software-defined radio ( SDR) is a radio communication system where components that conventionally have been implemented in analog hardware (e.g. mixers, filters, amplifiers, modulators / demodulators, detectors, etc.) are instead implemented by means of software on a computer or embedded system. [1] While the concept of SDR is not new, the ...