Search results
Results from the Think 24/7 Content Network
Radio control (often abbreviated to RC) is the use of control signals transmitted by radio to remotely operate a device. Examples of simple radio control systems are garage door openers and keyless entry systems for vehicles, in which a small handheld radio transmitter unlocks or opens doors. Radio control is also used for control of model ...
Block diagram of a crystal radio receiver Circuit diagram of a simple crystal radio. A crystal radio can be thought of as a radio receiver reduced to its essentials. [3] [39] It consists of at least these components: [22] [40] [41] An antenna in which electric currents are induced by radio waves.
Battery eliminator circuit. In battery-powered equipment, a battery eliminator circuit ( BEC) is an electronic voltage regulator used to power a subsystem at a different voltage without the need for a supplemental battery. BECs are commonly used in radio-controlled models, which need separate voltages to power the motor and the R/C equipment.
The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.
Radio transmitter design. A radio transmitter or just transmitter is an electronic device which produces radio waves with an antenna. Radio waves are electromagnetic waves with frequencies between about 30 Hz and 300 GHz. The transmitter itself generates a radio frequency alternating current, which is applied to the antenna.
Radio receiver design includes the electronic design of different components of a radio receiver which processes the radio frequency signal from an antenna in order to produce usable information such as audio. The complexity of a modern receiver and the possible range of circuitry and methods employed are more generally covered in electronics ...
Software-defined radio ( SDR) is a radio communication system where components that conventionally have been implemented in analog hardware (e.g. mixers, filters, amplifiers, modulators / demodulators, detectors, etc.) are instead implemented by means of software on a computer or embedded system. [1] While the concept of SDR is not new, the ...
t. e. Pulse-position modulation ( PPM) is a form of signal modulation in which M message bits are encoded by transmitting a single pulse in one of possible required time shifts. [1] [2] This is repeated every T seconds, such that the transmitted bit rate is bits per second. It is primarily useful for optical communications systems, which tend ...