Search results
Results from the Think 24/7 Content Network
USB ports and cables are used to connect hardware such as printers, scanners, keyboards, mice, flash drives, external hard drives, joysticks, cameras, monitors, and more to computers of all kinds. USB also supports signaling rates from 1.5 Mbit/s (Low speed) to 80 Gbit/s (USB4 2.0) depending on the version of the standard.
1xx—Provisional Responses. 100 Trying. Extended search being performed may take a significant time so a forking proxy must send a 100 Trying response. [ 1]: §21.1.1. 180 Ringing. Destination user agent received INVITE, and is alerting user of call. [ 1]: §21.1.2. 181 Call is Being Forwarded.
A USB cable, by definition, has a plug on each end—one A (or C) and one B (or C)—and the corresponding receptacle is usually on a computer or electronic device. The mini and micro formats may connect to an AB receptacle, which accepts either an A or a B plug, that plug determining the behavior of the receptacle.
In some instances USB through version 2 on motherboards – 2.54 mm pitch, 10 pins, 2×5 (2 rows of 5 pins) For all of the above connectors, the computer manufacturer typically attaches a female IDC connector onto one end of a ribbon cable, and later slides that connector onto a matching male box header or pin header on the computer motherboard.
In computing, a segmentation fault (often shortened to segfault) or access violation is a fault, or failure condition, raised by hardware with memory protection, notifying an operating system (OS) the software has attempted to access a restricted area of memory (a memory access violation). On standard x86 computers, this is a form of general ...
Low-density parity-check (LDPC) codes are a class of highly efficient linear block codes made from many single parity check (SPC) codes. They can provide performance very close to the channel capacity (the theoretical maximum) using an iterated soft-decision decoding approach, at linear time complexity in terms of their block length.
X.3.XXX Mail System Status. X.4.XXX Network and Routing Status. X.5.XXX Mail Delivery Protocol Status. X.6.XXX Message Content or Media Status. X.7.XXX Security or Policy Status. The meaning of the "detail" field depends on the class and the subject, and are listed in RFC 3463 and RFC 5248 . A server capable of replying with an Enhanced Status ...
Abort ( A ): Terminate the operation or program, and return to the command prompt. The program would not do any cleanup (such as completing writing of other files). Retry ( R ): Attempt the operation again. "Retry" was what the user did if they could fix the problem by inserting a disk and closing the disk drive door.